2 posts / 0 new
Last post
Andriesvk

Wiring output transformer

Hi
I started to restore a hd130 reverb head .
Someone replaced the output transformer with a non original.
Bought a better replacement.

I connected the primary side but i,m a bit confused about the secondary side

I got yellow 8ohm wich should be connected to the impedance switch

I got green 4 ohm wich should be connected to the lug on the opposite side
Of the impedance switch.

Then i got one lug left on the impedance switch wich should be connected to the speaker output jack

But then i got one purple wire left from the pre amp board and also a black one from the secondary side of the output tranny.

Where should these go?

Images: 
mgriffin155

Check Schematic

Take a look at these schematics as you install the OT. Good luck. -mgriffin
http://www.pacair.com/mmamps3/sites/default/files/docs/2475-130_and_2275...

Log in or register to post comments